• ›
  • Lab Tip: Substrate and Signal Reagents | Monobind

Troubleshooting Guide  ›  Good Lab Practices: Reagents

Lab Tip: Substrate and Signal Reagents

Reviewed by , Director of R&D  ·  Monobind Technical Support  ·  Updated

How should I handle ELISA substrates and CLIA signal reagents?

Confirm you have the correct reagent and lot, bring it to room temperature, mix two-part reagents just before use, check for blue coloration (a sign of contamination), and keep to the IFU incubation time.

Best practice

Monobind uses different ELISA substrates for kinetics (two-part ‘Sa + Sb’, single ‘Sn’ and single ‘Sc’) and one CLIA signal reagent (two-part ‘Ca + Cb’). Confirm the correct reagent and lot before use. Single-component reagents are ready to use once at room temperature; two-component reagents must be mixed before use, except where Monobind automation programs mix them while dispensing.

Check the reagent before use for contamination, which is often shown by blue coloration. Substrate incubation time is critical to performance, so keep to the times in the IFU.

Checklist

  • Confirm reagent type and lot
  • Mix two-part reagents just before use
  • Discard any substrate that looks blue
  • Time the substrate incubation exactly

Problems this helps prevent

Questions about your assay?

Send us your product, lot number, and plate data and our team will help.

This guidance supports general troubleshooting. Always follow the Instructions for Use (IFU) and Certificate of Analysis (CofA) for your specific Monobind test system and lot.